Errors during distribution of tp configuration – Could not start transport control program tp

I received below errors when I was configuring STMS. our system was copied from some other system.

Errors during distribution of tp configuration
Message no. XT454

Diagnosis
The tp configuration could not be distributed.

System Response
The function terminates.

Procedure
You can find a detailed error message in the TMS Alert Viewer (see TMS Alert Viewer).
Remove the cause of the error and execute the command again.

 

 

Could not start transport control program tp
Message no. TP608 Diagnosis

There was an attempt to start the transport control program tp using the local RFC interface. An error occurred here.

Error code: 4
RFC error text: timeout during allocate / CPIC-CALL: ‘ThSAPCMRCV’,

Meaning of the error codes:
03 RFC system failure
04 RFC communication failure

System Response
The function terminates. Details about the error can be found in the trace file of the Gateway Monitor (SMGW).

Procedure
Contact your system administrator or use report RSTPTEST to localize the error. You can then execute the command again.

 

Solution:

For me error was resolved after I configure hosts file with our hostname like below and restarted OS.

192.168.1.1             hostname                  hostname.domain.com

 

You can also check note 2433103 if needed.

 

Updated: October 18, 2018 — 2:10 pm

Leave a Reply

Your email address will not be published. Required fields are marked *

SAP and Errors and Solutions © 2016 to 2018 Frontier Theme
Copy Protected by Chetan's WP-Copyprotect.